All Sub mounts come in Black now. All Sub mounts are made for Over-sized bars, but the optional bar reducers allow 7/8" bars to be used. This Sub mount kit will require either over-sized handlebars, or bar reducers (if planning on using your stock diameter handlebars with this kit). Bar reducers must be ordered separately. Both the over-sized bars and bar reducers can be purchased online here via the product list. This kit is priced to include the special 8mm link-arm necessary to clear the frame on this model and the tool to install the link-arm. The stabilizer improves the handling of this model considerably. This kit typically will include:- a Stabilizer, link arm, - handlebar clamp, - frame bracket, - step by step pictured instructions, - owners manual and applicable hardware.Please note that handlebars are not included"SUB" mount stands for Stabilizer Under Bars, originally designed for raising the bars. These kits are designed for use with Oversize bars. "Bar reducers" are available as an option, to convert the kit to standard diameter bars, should that be desired. This concept allows more room for other equipment such as, Global Positioning Systems (GPS) or Enduro/Rally computers and yet still retain the quick access for adjusting the stabilizer. This is also good for the taller rider who wants his bars a little higher, as it raises the bar location approximately 11-25mm, depending on the model of bike. In some cases, you might consider a lower bend handlebar bend at the same time, unless you are trying to achieve a higher bar height along with your stabilizer installation. The SUB mounts are only available on certain models based on the physical limitations of mounting in this area. Each SUB mount comes complete with all necessary parts, hardware and "Step by Step" pictured instructions. The Photo attached here may be a generic photo to show you the basic components in the kit, but may not be showing the exact kit for your specific bike.